Care And Maintenance; Cleaning The Machine Surface; Cleaning The Race - Brother NX-250 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
APPENDIX

Care and Maintenance

Simple sewing machine maintenance operations are described below.
Cleaning the machine
surface
If the surface of the machine is dirty, lightly soak a
cloth in neutral detergent, squeeze it out firmly, and
then wipe the surface of the machine. After cleaning it
once with a wet cloth, wipe it again with a dry cloth.
CAUTION
●
Unplug the power cord before cleaning
the machine, otherwise injuries or an
electric shock may occur.

Cleaning the race

Sewing performance will suffer if dust collects in the
bobbin case; therefore, it should be cleaned
periodically.
1 Turn off the sewing machine.
2 Unplug the power cord from the power supply
jack on the right side of the sewing machine.
CAUTION
●
Unplug the power cord before cleaning
the machine, otherwise injuries or an
electric shock may occur.
3 Remove the flat bed attachment.
100
4 Remove the needle plate cover.
The needle plate cover is removed differently
depending on the model.
■ If there is a screw in the needle plate cover
Use the disc-shaped screwdriver to remove
1
the screw in the needle plate cover.
Grasp both sides of the needle plate cover,
2
and then slide it toward you.
1 Needle plate cover
The needle plate cover is removed.
■ If there is no screw in the needle plate cover
1 Grasp both sides of the needle plate cover,
and then slide it toward you.
1 Needle plate cover
The needle plate cover is removed.
a
a