Filling The Salt Reservoir - Miele G7104 Operating Instructions Manual

Filling the salt reservoir

Before filling the salt reservoir for the
first time, you must fill it with approx.
2 litres of water to enable the salt to
dissolve.
Once the dishwasher has been used,
there is always sufficient water in the
salt reservoir.
 Remove the lower basket from the
wash cabinet and unscrew the salt
reservoir cap.

Risk of corrosion due to saline
solution.
Water or saline solution will run out
of the reservoir when the cap is
opened. Saline solution that runs out
can cause corrosion in the wash
cabinet and to the dishwasher load.
The salt reservoir should therefore
only be opened to replenish the salt.
 Fill the salt reservoir with approx. 2 l
of water (first use only).
Using for the first time
 Place the funnel provided on the salt
reservoir and carefully fill with
dishwasher salt until the reservoir is
full. The salt reservoir holds up to
2 kg of salt, depending on the type of
salt used.
 Clean off salt residues from around
the salt reservoir opening. Next,
screw the salt reservoir cap on again
firmly.
 Immediately after filling the salt
container, run the  65 °C
QuickPowerWash programme with
the  Express option and without
any load in the dishwasher to
dissolve and remove any traces of
salt from the wash cabinet.
27