Miele G7104 Operating Instructions Manual page 93

Problem
White residue is visible
on the dishware.
Clouding has occurred
on glassware and
cutlery. The film can be
wiped off.
Possible cause and remedy
Not enough rinse aid was added.
 Increase the dosage (see "Settings – Rinse aid").
The salt reservoir is empty.
 Fill the salt reservoir (see "Using for the first time -
Dishwasher salt").
The salt reservoir cap has not been screwed on
correctly.
 Replace it, making sure that it screws back on
correctly.
Unsuitable combination detergents were used.
 Change your detergent. If using tabs or powder
detergent, do not choose combination products
and ensure you refill the reactivation salt and rinse
aid.
The water softener is programmed to a setting which
is too low for the water hardness level.
 Programme the water softener to a higher water
hardness level (see "Settings - Water hardness").
Too much detergent was dispensed.
 Reduce the dispensing quantity during automatic
dispensing (if available) (see "Settings – AutoDos").
 Activate the "Second interim rinse" function (see
"Settings - 2nd interim rinse").
Not enough combination detergent was dispensed.
The water softener performance is not sufficient.
 Increase the dispensing quantity during automatic
dispensing (if available) (see "Settings – AutoDos").
 Add more reactivation salt.
Problem solving guide
93