Page 2
Assembly Instructions 2/9 IMPORTANT Use a soft cloth between these parts and the floor. Do not use power tools above 8 volts to assemble. Do not tighten all the bolts until each part is properly assembled. The unit must be level to work properly.
Page 3
Assembly Instructions 3/9 Flat Washer Spring Washer Head Cap Bolt Tapered Bolt (long) STEP 2 Attach Side (C) to unit with Head Cap Bolts, Spring Washers, Flat Washers and Tapered Bolts (long), tightening bolts only halfway Tighten all bolts used in Steps 1 and 2. Figure 3 Flat Washer (large) Spring Washer...
Page 4
Assembly Instructions 4/9 STEP 4 Attach Side (G) to Back Frame (F) Flat Washer with Tapered Bolts (long), Spring Washer tightening bolts only halfway Head Cap Bolt Attach Rail (D) to unit with Head Cap Bolts, Spring Washers and Flat Washers, tightening bolts only halfway.
Page 5
Assembly Instructions 5/9 Flat Washer Spring Washer Head Cap Bolt Head Cap Bolt STEP 6 Spring Washer Flat Washer (large) Attach Side (H) to unit with Tapered Bolt (long) Head Cap Bolts, Spring Washers, Flat Washers, Flat Washers (large) and Tapered Bolts (long), tightening bolts only halfway.
Assembly Instructions 6/9 Basket (L) Tapered Bolt (short) Clip STEP 8 Figure 5 Attach Basket Side (L2) to Basket Unit (L1) with clips and Tapered Bolts (short). (See Figures 5 and 6) Figure 6 STEP 9 Clip Tapered Bolt (short) Attach Basket Side (L2) to unit with clips and Tapered Bolts (short).
Page 7
Assembly Instructions 7/9 Adjustable Pin STEP 10 Figure 7 Turn unit to its upright position. Insert Adjustable Pins into unit at desired level. (See Figure 7) Place Shelves (J) and Drawers (L) into position. Place unit at desired location. Note: If assembling multiple Closet Wall Units together place all units at desired location.
Assembly Instructions 8/9 IMPORTANT To help reduce the risk of the unit tipping over, the Tipover Restraint must be installed following these instructions exactly. STEP 11 Drill a 3/8” hole in wall in-line with Anchor in wall Wall Screw Pre-drilled hole Bracket pre-drilled hole at top of unit.
Page 9
Assembly Instructions 9/9 Wood Screw Bracket Figure 10 STEP 12 Note: If assembling multiple Closet Wall Units together, complete Step 12. Attach tops of units together with Brackets and Wood Screws into pre-drilled holes. (See Figure 10) Return to and complete Step 11.
Page 10
Home Styles is under no obligation to provide replacement parts. Parts are not available for fully assembled items nor are parts available for sale. Replacements for missing or damaged hardware or parts may be requested at: www.homestyles-furniture.com/customer-service/replacement-parts Home Styles Customer Service: www.homestyles-furniture.com, servicedesk@homestyles-furniture.com, 888-680-7460, 877-831-0319...
Need help?
Do you have a question about the Closet Wall Drawer Unit 20 05050 0075 and is the answer not in the manual?
Questions and answers