Use; Water Connection - Tebas INVERTER S User Manual

Use

Water connection

After connecting the heat pump to the swimming pool water system by means of an appropriate bypass, and after
• The device is placed horizontally on a solid surface.
• Whether the water system is filled with water = there is no air in the pipes or tank of the heat pump.
• Is the water system properly connected (no leaks, no risk of injury due to improperly fastened hydraulic
connections).
• The electrical installation is properly connected (all cables are firmly connected to the terminals and the
intermediate switch), insulated and earthed.
• The installation requirements described above are met.
• Is the ambient temperature: from -15 to + 35 ° C
• That the water temperature is between 15 and 30 ° C (50 ° F and 86 ° F).
The device can then be started. Whenever the pool heat pump is started up, especially at the start of the bathing
season, the following procedure must be followed in the order given:
• Open the three valves and then half-close the valve on the main pipe to the pool.
• Start the pool pump
• Turn on the pool heat pump using the switch (set to "I").
• Check that the device always starts up together with the filter pump: If the filter pump does not work, the
"flow" LED will turn off.
• The pool heat pump will start running with a delay of several minutes.
• Set the regulation (see chapter "Control").
• Set the heating (see chapter "Heating").
• After a few minutes (for the system to warm up), the water flow can be adjusted as described below (see
section "Adjusting the water flow").
After completing these activities, put the cover on the pool and let the heat pump run for a few days until the water
reaches the desired temperature.
Water outlet to the pool
Valve
Water inlet from the filter
making the electrical connections by qualified personnel, check the following:
Valve
Valve
Diagram of the bypass system
- 8 -
To the heat pump