Table of Contents
Advertisement
Contents
General Notes .............................................................................................................................
Cleaning Procedures ...................................................................................................................
Seals and o-rings ........................................................................................................................
Plastic or rubber components ......................................................................................................
Metallic Components ...................................................................................................................
Tools ............................................................................................................................................
Disassembly Procedure ................................................................................................................
Reassembly Procedure .................................................................................................................
Tuning and Final Testing .............................................................................................................
General Notes
This regulator is designed for use with Enriched Gas (Nitrox) to EAN40. Use only perfectly
cleaned tools in a cleaned environment
Cleaning procedure
Please refer to the "SCUBAPRO CLEANING PROCEDURE" document
Seals and O-Rings
•
All seals and o-rings shall be perfectly clean.
•
Check o-ring lands for imperfections or burrs, and clean as needed.
•
All o-rings, in particular those for dynamic use, must be lubricated, along with any adjacent
moving parts. The approved lubricant is Christolube MCG-111. Previous Technician
Seminars have indicated that Tribolube 71 is also acceptable, though this is not found in
official Scubapro publications.
•
Note: The lubricant container, as well as tools and brushes used for service must be
perfectly clean, free from dust, hydrocarbons or other particulate matter.
Plastic or rubber components
•
The components, particularly on sealing surfaces, should be free of deformation or damage.
•
All threaded components should screw freely and without resistance, leaving no excessive
gap, unless otherwise specified.
Metallic components
•
Metallic components should not have separated from the regulator or regulator part.
Chrome plating should be smooth without deformation, imperfections or damage.
2
2
2
2
2
2
3
4
6
9
Advertisement
Table of Contents
