Table of Contents
Advertisement
3�8�3 Clock
In this menu the internal clock can be set. The clock is used for the week sche-
dule for room temperature and to set time stamps on alarms and events. The
clock has internal backup and can keep running for a few days without exter-
nal power.
General alarm
In sub-menu Sum alarm you can select inactive, A and B alarms or A alarm.
etwork
3
In this menu you can see and change network settings such as IP-number, net
mask, and gateway.
�8�6 email
In this menu you can see and change settings for e-mail and e-mail receivers.
However, the E-mail sending of alarm messages can only be activated through
the web interface.
3�8�7 sms
In this menu you can see and change settings regarding SMS. SMS can only be
used when a compatible GSM/GPRS modem is installed. SMS sending of alarm
messages can only be activated from the web interface.
The first setting is a max limit for how many alarms are allowed to be sent
during a 24 hour period. This limit is there to prevent badly set alarm limits and
frequently reoccurring errors from spending too much money on SMS. When
the max limit has been reached, a final SMS is sent informing the receiver that
no more SMS will be sent until the SMS alarm is acknowledged.
Up to four phone numbers for SMS receivers can be defined. Remember that
the complete number, including the country code, has to be entered. The test
function can be used to send a test SMS to verify that the modem and telep-
hone numbers are working.
s
�8�8 restart
This menu contains a command to restart the heat pump controller system
without an interruption in power.
3�8�9 Factory settings
This menu contains a command to reset all settings to factory default. The
password and network settings are left unchanged.
Danfoss – 31
Advertisement
Table of Contents
