Shunt Groups; Cooling - Danfoss DHP-R 7Ua User Manual

alarm limit TWC in
Temperature limit for the low recirculation return temperature alarm.
alarm delay TWC in
Alarm delay for the low recirculation return temperature alarm.
legionella stop temp
Stopptemperatur för legionellakörning.
legionella calendar
Veckoschema för start av legionellakörningar.
3�6�9 shunt groups
Each of the eight shunt groups that can be installed in the system has its own
sub menu. Settings for a shunt group can be changed even if it is not active or
installed.
shunt 1 controller type
Select the shunt group function.
shunt 1 curve setting
Set point curve where the set point for different outdoor temperatures is set.
Only for outdoor temp compensated shunt groups.
shunt 1 set point
Set point for shunt groups keeping a constant temperature.
shunt 1 outdoor temp� stop
Outdoor temperature at which the circulation pump and controller for the
shunt group is stopped.
shunt 1 hysteresis
Hysteresis for restarting the circulation pump and controller.
shunt 1 p-area
P-area for the shunt controller.
shunt 1 i-time
I-time for the shunt controller.
shunt 1 pump exercise time
This setting determines how long time the circulation pump should be exer-
cised during each 24 hour period when stopped due to the outdoor tempera-
ture limit.
3�6�10 Cooling
The first element in the menu for cooling is the setting Config cooling, which
determines the cooling module's operation mode. Below this are sub menus
for settings regarding cooling subsystems.
Danfoss – 27