Wcs; Twc - Danfoss DHP-R 7Ua User Manual

Top up temp limit
This setting determines how much below Stop limit the temperature must be
for the top up function to be allowed to order a heat pump to produce hot
water instead of stopping.
3�6�7 WCs
Wcs setpoint
Set point for the water charge system.
Wcs p-area
P-area for the WCS-controller.
Wcs d-factor
D-factor for the WCS-controller.
Wcs ctrl start delay
When the circulation pump is started, the valve is first completely opened. This
setting decides how long the valve is to be kept fully open before the WCS
controller takes over.
min valve signal
If the valve should not close completely, this setting defines the minimum
shunt signal.
3�6�8 TWC
start temp out
Temperature limit on the hot water outlet for starting the heater.
stop temp out
Temperature limit on the hot water outlet for stopping the heater.
start temp return
Temperature limit on the hot water recirculation return for starting the heater.
stop temp return
Temperature limit on the hot water recirculation return for stopping the hea-
ter.
start delay out
Delay time for starting the heater due to low hot water outlet temperature.
start delay return
Delay time for starting the heater due to low hot water recirculation return
temperature.
alarm limit TWC out
Temperature limit for the low outlet temperature alarm.
alarm delay TWC out
Alarm delay for the low outlet temperature alarm.
26 – Danfoss