WANHAO Duplicator i3 First Run Experience page 9
Hide thumbs
Also See for Duplicator i3:
- Software user manual (25 pages) ,
- User manual (16 pages) ,
- Step by step installation instructions (12 pages)
Advertisement
You'll have to wait for a few minutes for them to heat up. Be careful not to touch
the bottom of the Step exstruder while it's heating -- it gets up to about 220° C,
which is hot and can burn you! 4.6 - 4.7
Once the nozzle is at temperature, The Duplicator 3 will tell you to load filament in
the right-hand Step exstruder. 4.8
Advertisement
Need help?
Do you have a question about the Duplicator i3 and is the answer not in the manual?