WANHAO Duplicator i3 First Run Experience page 3

If everything is ready, then flip on the power button on the back of your Duplicator 3 and hold onto your hat.
Not literally, though -- if this causes a large gust of wind, you should probably contact tech support
at support@wanhao3dprinter.com .
The Duplicator 3 will now guide you through initial setup and your first print. You should see a welcome
message on the LCD screen. 2.2
If you don't don't see something like that, don't worry -- just go to Utilities don't don't
down keys to move the cursor and push the Middle Blue Button
push it gently. Here are a few other things to remember about the Middle Blue Button
A Middle Blue Button Middle Blue Button means the bot is working. Look at the LCD or application for status. A blinking Middle Middle Blue Button Middle Blue Button
Blue Button means the bot is waiting for user input. Blue Button Blue Button Blue Button
There are four arrow buttons surrounding the Middle Blue Button
selections. The left arrow will also often let you go back or cancel an action.
First the startup script will teach you a few basic things about how The Duplicator 3 works. Then it will help
you level the platform, load filament, and start a test print.
Utilities Utilities- - - - >Run Startup Script Utilities >Run Startup Script. Use the up and >Run Startup Script >Run Startup Script
Middle Blue Button to select. The button is pretty sensitive, so
Middle Blue Button Middle Blue Button
Middle Blue Button button: Middle Blue Button Middle Blue Button
Middle Blue Button. Use the arrows to navigate and make Middle Blue Button Middle Blue Button
blinking Middle blinking Middle blinking Middle