WANHAO Duplicator i3 First Run Experience page 2

The Duplicator 3 First Run Experience The Duplicator 3 First Run Experience The Duplicator 3 First Run Experience The Duplicator 3 First Run Experience
Safety Information Safety Information
Safety Information Safety Information
1.1 Caution Caution: The Duplicator 3 generates high temperatures and includes moving parts that can cause injury. Never reach Caution Caution
inside the Duplicator 3 while it is in operation, and allow time for the Duplicator 3 to cool down after operation.
The Duplicator 3 is sensitive to electrostatic discharge. Make sure you don't have a static charge on you by
touching a grounded object before operating The Duplicator 3 or attempting any adjustments. If opening The
Duplicator 3 for service, ensure that the power supply is turned off and the cord is disconnected.
All set All set All set All set
First, make sure that you've completed all the steps in the Unboxing and Hardware Setup section: your
StepStruder MK8 should be bolted in place, your filament guide tubes connected, and your spools of filament
mounted on the spool holders. You can plug in your power supply now, too. 2.1