HAMPTON BAY G-FTB-51057B Use And Care Manual page 13

Operation (continued)
LIGHTING INSTRUCTIONS
1. Press and hold electronic igniter button.
2. Turn the burner control to the high position, press and hold. When the burner
lights, release the electronic igniter button.
3. Continue to depress the burner control knob for 30 seonds and then release.
If the ame goes out, repeat the procedue.
4. Adjust the ame to the desired height with the burner control knob. Visually
check the burner ames as pictured be low.
5. If the burner will not light with the electronic igniter, hold a lit long match or
lit long butane lighter to the ignition area of the burner and continue with
step 2.
6. To shut down the burner turn the burner control knob clockwise to the off
position. Then turn the gas off at the source (propane cylinder valve).
Normal
FOR YOUR SAFETY:
Keep face and body away from burner area
when lighting.
Ensure burner controls are in the off position.
Slowly turn on the gas supply valve.
FOR YOUR SAFETY:
The propane cylinder is equipped with an excess
ow device. Unless burners are turned off prior
to turning the cylinder on, only small ames and
low heat will be achievable.
FOR YOUR SAFETY:
If the burner does not light within 10 seconds,
turn the valve off and wait 5 minutes for any gas
to dissipate before repeating the procedure.
FOR YOUR SAFETY:
Surface of the re pit can remain extremely hot
for a period after use.
Allow 45 minutes to cool down before touching
or moving the re pit.
13
Please contact 1-855-HD-HAMPTON for further assistance.
WARNING
WARNING
WARNING
WARNING
HAMPTONBAY.COM