Brother HL-630 User Manual page 58

USER'S GUIDE
Error
Memory Full
Print Overrun
Centronics
Interface Line
Error
Serial Interface
Framing Error
Serial Interface
Parity Error
Serial Interface
Overrun Error
6–2
For errors shown below, the printer indicates an operator call by
blinking the ALARM lamp and printing the error messages on paper.
Action
Press the FF/CONT switch to print the data
remaining in the printer.
If you are using the supplied Windows driver, try
again after setting the TrueType mode to "Print as
Graphics" in the PRINT menu of your application
software.
Expand the printer memory with the optional
memory board.
Reduce the print resolution or reduce the
complexity of your document.
Press the FF/CONT switch to print the data
remaining in the printer.
If you use the supplied Windows driver, try again
after setting the TrueType mode to 'Print as
Graphics' in the PRINT menu of your application
software.
If this does not clear the error, reduce the
complexity of your document or reduce the print
resolution.
Press the FF/CONT switch to resume printing.
Check that the connection between your computer
and printer is secure and correct, and check the
interface cable.
Press the FF/CONT switch to resume printing.
Check the communication parameters settings such
as baud rate and stop bit on both your computer and
printer.
Press the FF/CONT switch to resume printing.
Check the communication parameters settings such
as bit length and parity on both your computer and
printer.
Press the FF/CONT switch to resume printing.
The interface hardware may be damaged, consult
your dealer.