Setting The Serial Interface Parameters - Brother HL-630 User Manual

Setting the Serial Interface Parameters

Note
This section is only for printer models which have had the serial interface
installed.
Caution
Be sure to set the parameters to match your computer as follows:
Never change the RS-422A parameters for Apple Macintosh
computers. The RS-422A parameters have been correctly set at the
factory for Apple Macintosh computers, you do not need to change
the setting. You may skip this section. If you change parameters for
the RS-232C serial interface and you switch back to RS-422A for
Apple Macintosh computers, be sure to restore the parameters to the
factory settings.
Set the RS-232C parameters to match your computer. You can set
serial settings in several different places, within your DOS
application, within the Windows Printer Icon (for Windows
application software only), or within your AUTOEXEC.BAT file
using MODE commands. For information on serial interface
parameters, see the user's guide of your computer or software.
If necessary, set the serial interface parameters as follow:
1. Make sure that the printer is in the off-line state.
2. Set the serial interface parameters by moving up (on) or down (off)
the selectors of the dual in-line package (DIP) switch.
Fig. 4-3 Setting the Serial Interface Parameters
CHAPTER 4 OPTIONS
ON
1 2 3 4 5 6 7 8
4–3