Setting Up The Printer For Apple Macintosh Computers - Brother HL-630 User Manual

Laser printer
Hide thumbs Also See for HL-630:
Table of Contents

Advertisement

USER'S GUIDE
Questions
I cannot print from my
application software.
How can I change the
printer's default settings?
Sometimes I get a Print
Overrun error when
printing certain
documents from
Windows.
Sometimes I get the
Memory Full message.
How can I correct this?

Setting up the Printer for Apple Macintosh Computers

Questions
The printer does not
print.
6–10
Recommendation
If you are using Windows 3.1, make sure
the supplied printer driver is installed and
selected with your application software.
If you are using Windows 3.0 or earlier,
make sure that proper printer driver is
installed and selected to match the printer
emulation.
If you use the serial interface, make sure
that the serial slide switch of the serial
interface is in the correct position and the
interface settings are correctly set up with
the DIP switches.
Exit to DOS and use the remote printer console
program.
Set the TrueType mode to 'Print as
graphics' from the PRINT menu in your
application software.
Reduce the print resolution or reduce the
complexity of your document and try
again.
Set the TrueType mode to 'Print as
graphics' from the PRINT menu in your
application software.
Another solution is to purchase more
memory.
Reduce the print resolution or reduce the
complexity of your document and try
again.
Recommendation
Check the following:
The printer is plugged in.
Paper is loaded.
No error conditions are active (any blinking
lamps on printer.)
Printer is on-line.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents