Assembly; Unpacking; Installation Requirements; Mounting Orientation - Bosch Rexroth BS 2/C Series Assembly Instructions Manual

16/76

Assembly

1 2
Bosch Rexroth AG, MIT: BS 2/C-... + BS 2/R-..., 3 842 358 724/2013-04
7 Assembly

7.1 Unpacking


Lift the product out of the packaging.

Dispose of the packaging in accordance with the currently applicable national
regulations in your country.

7.2 Installation requirements


When installing the product, always observe the ambient conditions specifi ed
in the Technical Data (see page 75).
7.2.1

Mounting orientation


The product should be aligned and level at right angles and parallel to the axis.
This ensures correct functioning and prevents premature wear.
7.2.2

Mounting with T-bolts


Mount the transfer systems TS 1, TS 2plus, TS 2pv, TS 4plus, TS 5 and chain
conveyor systems VarioFlow and VarioFlow S with T-bolts and fl ange nuts.

Make sure the T-bolt is in the correct position when inserting and tightening
in the slot. The notch at the end of the bolt indicates the T-bolt orientation.

1 = T-bolt insertion orientation in the slot.

2 = T-bolt clamping position in the slot.

Maximum tightening torque: 25 Nm.

7.3 Required tools


Hexagon wrenches (open-end):
WS8, WS10, WS13, WS19, WS24.

Hex socket wrench: WS4.

Water level

Combination pliers

Flat smooth fi le