Note: Marquees are intended for events and other arrangements and are as such only meant for short term temporary assembly and the following disassembly. Dancover warranty applies only to the normal use of the Product, normal wear and tear excepted, in accordance with written use instructions or manual.
Page 5
STEP 1 STEP 2 STEP 2: Attach Crossbeams 1 (Part B) and Crossbeams 4 (Part C1) to Pillars (Part A) . Attach Support Brackets ( Part F and F1) to Crossbeam and Pillar. Attach Crossbeams 2 Part B1) and Crossbeams 3 (Part C) to Pillars (Part A). Attach Support Brackets (Parts F and F1) to Cross Beam and Pillar...
Page 6
STEP 3:Connect the Ionger Crossbeams B and B1 using Crossbeam Connector (Part P) STEP 3 Note: After sliding the Crossbeam Connector (Part P) into a crossbeam you should start one bolt to hold the Crossbeam Connector in place. STEP 4 STEP 4: Stand both sides Upright and Connect Crossbeams B and crossbeams B1 using the Crossbeam Connectors (Part P)
Page 7
STEP 5-1 STEP 5-1: Attach the Corner Protectors (Part J1) and the Rib Supports (Part J2) Just twist the top two screws of (Part J2) STEP 5-2 STEP 5-2: Slide 7 Netting Hooks (Part Q) into Long Crossbeams (Parts B and B1).
Page 8
STEP 6: Assemble the Roof Frame by Attaching the Roof Ribs Long (Part E) to the STEP 6 Roof Top Brace (Part K1). STEP 7...
Page 10
STEP 10 STEP 10: Attach the Clips (Part R1) and Clips (Part R) as shown in the diagram. R/R1 Tap lightly with the screwdriver STEP 11 STEP 11:Install the Roof Plates (Part N6 N7 N8) on the Long Sides of the Gazebo. Install the Roof Plates (Part O5 O6) on the Short Sides of the Gazebo.
Page 11
STEP 12 STEP 12:Tighten the screw (part U) halfwy,then install(Part G G5 G6 G7), and finally tighten the (Part U) G5/G6 G7/G STEP 13 STEP 13: Attach the Roof Supports (Part H H1 H2) to the roof frame using Connectors 1 (Part M3) and Connectors 2 (Part M4) as Don't tighten all the screws, just shown in the diagram...
Page 12
STEP 14 STEP 14:Part N1 N2 N3 N4 N5 for the Long Sides of the Gazebo, Part O1 O2 O3 O4 for the short Sides of the Gazebo. Install the Roof Plates on the Long Sides of the Gazebo. Start by sliding Roof Plate 1 (Part N2 N3 N4) into position.
Page 13
STEP 16 Note: First fix 4 (Part M2) with V, but do not screw too tight, then install (Part G G1 G2 G3 and G4 )as shown in the diagram. You'd better from left to right. Attach the Center Rib Braces (PartM1) as shown in the diagram.
Page 14
STEP 18 STEP 18: Install the Mosquito Netting as Shown in the diagram.
Page 15
Head office: Dancover A/S For more information Lyngevej 16A, Nørre Herlev please visit: 3400 Hillerød www.dancovershop.com Denmark...
Need help?
Do you have a question about the San Francisco and is the answer not in the manual?
Questions and answers