Related Manuals for Pyle PT110
Summary of Contents for Pyle PT110
- Page 1 PT110 80 Watt AC/DC Microphone PA Mono Amplifier with USB/SD/FM/BT LED Level Display w/ 70V Output & Mic Talkover...
-
Page 2: Features And Controls
INTRODUCTION PYLE PT110 PA AMPLIFIER Your New gives you the power and versatility you need in a professional sound system. The ampli er's wide frequency response makes it suitable for amplifying music or vocal program material. It can be used for live bands, o ce paging systems, public announcements, or a variety of other installations. -
Page 3: Control Panel Button
3. MIC 1 & MIC 2 Jack: Allows you to connect up to two 6.35mm type microphone. 4. LED Level Display Meter 5. MIC Volume Control: Lets you adjust the MIC1/MIC2 sound level. 6. Three Input Sources Mixing Controls: Controls the sound level for each of the audio input sources. - Page 4 STEPS FOR CONNECTING WITH WIRELESS BT DEVICE A. Press MODE button under the ID3 display screen and enter into BT mode. B. Search for the Wireless BT device and nd the BT name “PYLEUSA or BT” C. Select the PYLEUSA or BT Wireless BT name and wait for the device to pair. D.
-
Page 5: Connecting Microphones
Connecting Microphones Speaker Connections One or more speakers (4, 8, or 16-Ohm) The MIC 1 and MIC 2 jacks permit you speakers can be connected to the to connect two microphones with ampli er with or without transformers. 6.35mm plug. However, before you connect any speaker to the ampli er, the total speaker impe- dance must be calculated in order to... -
Page 6: Right Speaker
System 2: Two (or more) speakers in System 3: Two (or more) speakers in parallel series 1. Connect the LEFT SPEAKER (-) to the 1. Connect the LEFT SPEAKER (-) to the RIGHT SPEAKER (-). ampli er COMMON terminal. 2. Connect BOTH the LEFT SPEAKER (-) 2. - Page 7 3. Connect the two pairs of speakers in PARALLEL. If you connect 8-ohm speakers, the total impedance of both pairs is 8 ohms. Note: If each of the four speakers is 8 ohms, the total speaker impedance of the combined series/parallel connection described above is also 8 ohms.
- Page 8 SERIES/PARALLEL VARIATIONS Although the description above is for combining TWO SERIES PAIRS in a PARALLEL hook up, you may also select to combine a SERIES PAIR and a PARALLEL PAIR in a PARALLEL hook up. Simply be sure you have properly calculated the total impe- dance, and connect the (+) speaker circuit wire to the proper amp terminal.
- Page 9 NOTE: • Before connecting the speakers, please be sure the total wattage of the primary tap you use does not exceed the ampli er's maximum power rating, PT110 20W and PT210 40W. • Avoid, where possible, multiple connections to the 70V RMS and COMMON terminals.
-
Page 10: Using Headphones
Using Headphones To listen privately, or to monitor sound sources, connect a pair of low impedance stereo headphones (not supplied) with 6.35mm plug into the PHONES jack on the ampli er front panel. Please listen safely. Follow these recommendations: Do not listen at extremely high volume levels. Extended, high-volume listening can lead to permanent hearing loss. - Page 11 Using the MIX BUS jack You can connect another PT110/ PT210 to this jack to double the size of your PA system. This lets you use up to four microphones and two turntables (or two auxiliaryies) sound souces. Use a shield cable with phono plugs at each end, and connect the cable between the MIX BUS jacks on the back of two ampli ers.
-
Page 12: Remote Control
Remote control 1. Press this button to turn ON or OFF the MP3. 2. When in the FM mode, press this two buttons to tune FM Frequency. 3. Press these two buttons to select the previous or next track in USB or SD or Wireless BT mode, to select previous or next channel in FM model. - Page 13 • Variety of Speaker Outputs Terminal • USB/SD/FM/ LED Display & Wireless BT Features • Includes Wireless BT Antenna to Improve BT Distance • Includes FM Antenna to Improve FM Sensitivity Wireless BT Connectivity: • Simple & Hassle-Free Pairing Ability •...
- Page 14 Questions? Issues? We are here to help! Phone: (1) 718-535-1800 Email: support@pyleusa.com...
Need help?
Do you have a question about the PT110 and is the answer not in the manual?
Questions and answers