Configuring The Base Station - Tait TB8100 Using Manual

Hide thumbs Also See for TB8100:

Configuring the Base Station

TN-1114-AN

Extended bypass is configured in the channel profile assigned to the

operating channel. If a different operating channel is selected, the signal

path configured for that channel will take effect.

Important

Selecting this function bypasses the limiter. This may allow

overdeviation and cause the equipment to become non-

compliant. It should be selected only when the TB8100 is

connected to approved level-controlled devices (modems,

trunking controllers, etc.).

Important

With extended bypass you cannot use the balanced line or

internal talk-through repeater connections from receiver to

transmitter.

To configure the signal path for extended bypass.

Run the Service Kit and open the Add or Edit Channel Profile dia-

logue box for the appropriate profile.

Select the Signal Path tab.

Select the Bypass check boxes for Path B (both transmit and receive).

Extended bypass check boxes appear alongside the Bypass check

boxes.

Page 7 of 10

Table of Contents