National Instruments MXI Getting Started page 38

© National Instruments Corporation
Table A-7. VXI-MXI-2 Hardware Default Settings (Continued)
Hardware Component
MXIbus termination
(U35 switches 1 and 2)
Configuration EEPROM
(U35 switches 3 and 4)
DRAM SIMMs installed
SIMM size configuration (S6)
Table A-8. VXI-MXI-2/B Hardware Default Settings
Hardware Component
Logical address (U20)
VXIbus Slot 0/Non-Slot 0 (W3)
VXIbus local bus (W2)
VXIbus CLK10 routing (W1)
External trigger termination (S5)
SMB CLK10 direction (S7)
SMB CLK10 termination (S6)
Polarity of external SMB CLK10
(S3)
MXIbus CLK10 signal (S1)
A-5
Appendix A
Default Setting
Automatic MXIbus
termination: switch 2 set to
NO; switch 1 ignored
User-modifiable; factory
settings protected: both
switches set to NO
Per customer order
OFF if SIMMS are 4 M × 32
or larger; ON if smaller than
4 M × 32
Default Setting
1
Automatic detection
Single VXI-MXI-2/B in frame
From onboard oscillator
OFF: unterminated
OUT: drive CLK10 signal
Ignored; effective only when
S7 is set to IN
Inverted
Receive CLK10 from MXIbus
PCI-Based MXI-2 Interfaces for Windows 2000/NT/Me/98
Default Settings