Brother MFC-8220 User Manual page 150

ERROR MESSAGES
ERROR CAUSE
MESSAGE
Poor phone line quality caused
Comm. Error
communication error.
You tried to poll a fax machine that is not in
Connection
Polled Waiting mode.
Fail
The temperature of the drum unit or toner
Cooling Down
cartridge is too hot. The MFC will pause its
Wait for a
current print job and go into cooling down
while
mode. During the cooling down mode, you will
hear the cooling fan running while the display
on the MFC shows Cooling Down, and Wait
for a while.
The front cover was not completely closed.
Cover Open
Pls Close
Cover
The other party or other party's fax machine
Disconnected
terminated the call.
The MFC is set to Distinctive Ring mode. You
DR Mode in
can not change the Receive Mode from
Use
Manual to another mode.
The MFC cannot scan the original document
Error Scanning
correctly.
Turn off and
on the
machine, then
try again.
The temperature inside of the MFC is too hot
Fuser Error
or too cool.
Turn off and
on. Leave the
machine for
10 min.
The jam clear cover (fuser cover) is open.
Fuser Open
The MFC has a mechanical problem.
Machine Error
XX
The number you dialed does not answer or is
No
busy.
Response/Busy
You tried to access a One-Touch or
Not
Speed-Dial number that is not programmed.
Registered
TROUBLESHOOTING AND ROUTINE MAINTENANCE 12 - 2
ACTION
Try the call again. If problem
continues, call Telephone Company
to check your phone line.
Verify the other party's polling setup.
Wait a while for the MFC to cool.
Close the front cover for the drum
unit.
Try to transmit or receive again.
Set Distinctive Ring to Off.
(See Turning off the Distinctive Ring
on page 5-12.)
Please remove the original
document from the ADF. Turn the
MFC power on and off, and then try
again.
Turn the MFC power off and on
again, and then leave the MFC for
10 minutes. If the LCD still shows
Fuser Error or changes to
Machine Error, call Brother
Customer Service.
Please close the jam clear cover
(fuser cover). (See Paper jams on
page 12-5.)
Call Brother Customer Service and
tell them the Machine Error number.
In USA: 1-800-284-4329
In Canada: 1-877-BROTHER
Verify the number and try again.
Set up the One-Touch or Speed-Dial
number. (See Storing One-Touch
Dial numbers on page 7-1 and
Storing Speed-Dial numbers on
page 7-3.)