Table of Contents
Advertisement
ECM (Error Correction Mode)
The Error Correction Mode (ECM) is a way for the MFC to check a
fax transmission while it is in progress. If the MFC detects errors
during fax transmission, it resends the pages of the fax that had
an error. ECM transmissions are only possible between fax
machines that both have this feature. If they do, you may send and
receive fax messages that are continuously being checked by the
MFC.
Your MFC must have enough memory for this feature to work.
Connecting the MFC
Connecting an external telephone
Your MFC is equipped with a handset that you can use as a regular
phone. However, you can also connect a separate telephone (or
telephone answering device) directly to your MFC.
Connect the telephone's line cord to the jack labeled EXT. on the
back side of the MFC.
When this phone (or TAD) is in use, the LCD shows
Ext. Tel in Use , and, if the fax handset is lifted, an alarm sounds.
To disconnect a call on the external phone and switch to the fax,
Hook/Hold
press
Whenever this phone (or TAD) is in use, the LCD shows
Ext. Tel In Use .
1 - 11 INTRODUCTION
.
External
Telephone
Extension
Telephone
Advertisement
Table of Contents
