U-Line H-1482 Quick Start Manual

U-Line H-1482 Quick Start Manual

Steel tensioner

Advertisement

Available languages

Available languages

H-1482
DELUXE STEEL TENSIONER

THREADING TENSIONER

1.
Wrap both ends of strapping around product.
2. Sandwich strapping with the bottom strap facing
towards you.
3. Squeeze handle towards base and insert strapping
under the gripper.
4. Pull strapping as close to product as possible to
reduce amount of tensioning that will be necessary.
(See Figure 1)
Figure 1

TENSIONING

1.
Move handle back and forth to begin tensioning
2. Continue back and forth motion until strapping has
reached desired tension. (See Figure 2)
Figure 2
PAGE 1 OF 3
1-800-295-5510
uline.com

OPERATION

SEALING

1.
Place the seal. Seal should be placed open side
down on top of both pieces of strapping.
2. Close nose of sealer around seal.
3. Crimp tightly around strapping.
4. Repositioning the tightening handle:
• If handle is in forward position you will need to push
handle pawl forward and allow handle to fall to the
base (this allows you to remove the tensioner when
finished or to realign strapping during tensioning)
5. Remove excess strapping
• When finished, cut excess strapping with a strapping
cutter. (See Figure 3)
Figure 3

MAINTENANCE

Tools do need to be cleaned and maintained
periodically with a steel brush or dry compressed air.
Lubricate all moving parts with light machine oil.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0421 IH-1482

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the H-1482 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for U-Line H-1482

  • Page 1 Para Español, vea página 2. Pour le français, consulter la page 3. H-1482 1-800-295-5510 uline.com DELUXE STEEL TENSIONER OPERATION THREADING TENSIONER SEALING Wrap both ends of strapping around product. Place the seal. Seal should be placed open side down on top of both pieces of strapping.
  • Page 2 H-1482 800-295-5510 uline.mx TENSIONADORA DE ACERO DE ALTA CALIDAD FUNCIONAMIENTO ENSARTAR LA TENSIONADORA SELLAR Envuelva ambos lados del fleje alrededor del 1. Coloque el sello. El sello debe colocarse con el producto. lado abierto hacia abajo, por encima de ambos tramos de fleje.
  • Page 3 H-1482 1-800-295-5510 uline.ca TENDEUR DE LUXE POUR FEUILLARD EN ACIER FONCTIONNEMENT ENFILAGE DU TENDEUR SCELLAGE Entourez le produit avec les deux extrémités du Placez le joint. Le joint doit être placé sur le dessus feuillard. des deux morceaux du feuillard, côté ouvert vers le bas.

Table of Contents