Operation; Communication; Hart; Communicator Dxr 275 - Endress+Hauser iTEMP HART TMT 182 Operating Instructions Manual

5 Operation

2
2
40
5 Operation
5.1

Communication

The temperature head transmitter is set up using the HART
measured can also be read using the HART
two possibilities:
• Operation using a universal hand operating module "HART
275".
• Operation using a PC and operating software (e.g. Commuwin II) as well as a HART
modem (e.g. "Commubox FXA 191").
®

5.1.1 HART

Communicator DXR 275

Selection of the unit functions using the "HART
menu levels as well as with the help of a special HART
Hint!
• When using the HART
programming is blocked. It is possible to release the HART
ing 281 in the LOCK function. This condition remains even after a power failure. The
®
HART function matrix can be locked again by releasing the personal code number.
• More detailed information to the HART
respective operating manual in the carrying case.

5.1.2 Commuwin II-operating programme

Commuwin II is a universal programme for remote operation of field and panel-mounted
instrumentation. Application of the Commuwin II operating programme is possible
independent of the type of unit and communication mode (HART
Commuwin II offers the following functions:
• Setting up unit functions
• Visualisation of measured values
• Data security of unit parameters
• Unit diagnostics
• Measurement point documentation
Hint!
More detailed information to Commuwin II can be found in the E+H documentation:
• System Information: SI 018F/00/en "Commuwin II"
• Operating manual: BA 124F/00/en "Commuwin II" operating programme
Open the field housing PG cable gland and connect the
screen of the output and sensor connection according to the
figure opposite (s. fig. 4-4)
When using earthed thermocouples, screening of the output
cable (4 ... 20 mA cable) is recommended.
In plants with strong EMC problems screening of all cables
with a low ohm connection to the transmitter housing is
recommended.
Fig. 4-4: Screening on remote installation
®
protocol. In order to do this the user has
®
®
hand unit all parameters can be read out, however,
®
hand operation module can be found in the
Temperature head transmitter
®
protocol. The values
®
Communicator DXR
-Communicator" is done using various
®
function matrix (see page 42).
®
function matrix by enter-
®
or PROFIBUS
Endress+Hauser
®
®
).