Selecting Sounds; Recalling/Saving A Scene (Scene Select Mode); Recalling A Scene; Switching Between Scene Banks And Recalling Scenes - Roland Jupiter-Xm Reference Manual

Selecting Sounds

On the JUPITER-Xm, you select a scene and play the sounds that are
assigned to each of the five parts.
Bank number–Scene number
Current part name
9:
Key Sw is ON
8:
Key Sw is OFF
– : Part Sw is OFF
+:
Arpeggio part
—: Current part
5 :
Being edited
simultaneously
Recalling/Saving a Scene
The JUPITER-Xm can store a total of 256 scenes, organized as 16 banks each
containing 16 scenes.

Recalling a Scene

1 .
Press the [SCENE] button
* The SCENE TOP screen is the first screen that appears when you turn on the
power.
* When the [PART] button is lit, press the
TOP screen.
2 .
Use the [1]–[16] buttons
Switching between scene banks and
recalling scenes
1 .
Hold down the [SHIFT] button
buttons to select a scene bank .
2 .
Use the [1]–[16] buttons
* To recall a different scene bank than the one that's currently selected, select
the scene bank and then press the
* You can also use the [1] and [2] knobs
the same time you turn the knob.
MEMO
The system parameter "Startup SCENE"
selected at start-up.
&
"System Parameter List" (p. 43)
Current internal
Scene Name
temperature
Bluetooth Sw
9:
PARTIAL Sw is ON
8:
PARTIAL Sw is OFF
– :
Being edited
Power cord connected/
disconnected
(Scene Select Mode)
to enter scene select mode .
[PART] button to return to the SCENE
to select a scene .
and press the [1]–[16]
to select the scene .
[1]–[16] buttons.
to switch scenes. The scene changes at
lets you specify the scene that is

Selecting a Scene from a List

1 .
Press the [SCENE] button
The SCENE TOP screen appears.
The [1]–[16] buttons switch to scene select mode.
2 .
Press the [ENTER] button .
The scene list appears.
3 .
Use the [2] knob to select a scene .
You can also make this selection by using the
instead of the [2] knob.
Alternatively, you can use the
scene bank.
4 .
Press the [ENTER] button

Saving a Scene

The edits that you make to a part or tone, or the data that you record, are
temporary. They are lost when you turn off the power, or when you select
another scene or tone. If you want to keep the result of your editing or
recording, you must save it to a scene.
* If you want to save a tone individually, use the tone write operation (p. 8).
1 .
Press the [SCENE] button, and then press the
button .
The WRITE MENU screen appears.
2 .
Use the [1] knob to select
[ENTER] button .
3 .
Use the [2] knob to select the save-destination, and then
press the [ENTER] button .
If you want to rename the scene that's being saved, use the
buttons to move the cursor and use the
4 .
Press the [ENTER] button .
A confirmation message appears.
If you decide to cancel, press the
5 .
To execute, press the [ENTER]
to enter scene select mode .
PAGE [ ] [ ] buttons
[1] knob to jump to the previous or next
to confirm the scene .
[WRITE]
"SCENE," and then press the
PAGE [<] [>]
[2] knob to specify characters.
[EXIT] button.
button .
13