Advertisement
α2000 /1000 Gimbal Firmware Upgrade Manual
Attention
1. Please install the battery before firmware upgrade.
2. The upgrade software and USB driver are compatible with the Mac OSX.
3. Please do the operations step by step strictly.
4. If you want to check current firmware version, please execute step 1-7.
Steps
1. Download the latest firmware, update software and the USB driver from
our official website
usage.
2.
Double click on"USB Driver for Mac.dmg"to get "Silicon Labs VCP
Driver Install Disk" .Double click on"Silicon Labs VCP Driver Install Disk"
to get"Silicon Labs VCP Drive.pkg". Double click on "Silicon Labs VCP
Drive.pkg"to install the USB driver, finish it step by step.
Guilin Feiyu Technology Incorporated Company
Guilin Feiyu Technology Incorporated Company
for Mac
http://www.feyu-tech.com
- 1 -
, Unzip them for further
www.feiyu-tech.com
service@feiyu-tech.com
Advertisement
Table of Contents
Related Manuals for Guilin Feiyu Technology a2000
Summary of Contents for Guilin Feiyu Technology a2000
- Page 1 Guilin Feiyu Technology Incorporated Company α2000 /1000 Gimbal Firmware Upgrade Manual for Mac Attention 1. Please install the battery before firmware upgrade. 2. The upgrade software and USB driver are compatible with the Mac OSX. 3. Please do the operations step by step strictly.
- Page 2 Guilin Feiyu Technology Incorporated Company 3. Put the battery into the gimbal, please refer following connection diagram, connect the USB cable with USB port of Mac and the gimbal. The charging indicator on the handle of gimbal will be on(charging status).
- Page 3 Guilin Feiyu Technology Incorporated Company 5. Double click on“Feiyu Firmware tool.dmg” to get “Feiyu Upgrader”. Double click on “Feiyu Upgrader” to get “Feiyu Gimbal Upgrader”. Double click on “Feiyu Gimbal Upgrader”to run the software. 6. The software interface is shown as the following picture. Select “SLAB_USBtoUART”and baud rate as “115200”, click on“Open”button.
- Page 4 Guilin Feiyu Technology Incorporated Company 8. Click on “Browse” button and choose right firmware for the gimbal， then click on“Start” to start updating. The blocks will be sent one by one. 9. After all the blocks of the firmware are completely sent ,“Upgrade Complete”will be shown.
- Page 5 Guilin Feiyu Technology Incorporated Company 10. Long press the function button of the gimbal to turn down the gimbal. The upgrade is done. NO.1 “ Gimbal Connected ” didn't show up when pressing the function button. ① Please check whether tightly plug in USB cable with USB port, and the USB cable is right cable from our standard accessories.
- Page 6 Guilin Feiyu Technology Incorporated Company COM”button. If you did all the things right, please replace a new USB cable and try again. NO.2 When “ Gimbal Connected ” and the version of current firmware showing up, click on “Start”, but no luck, “SEND FAIL” just show up to remind me the update don’t work.
Need help?
Do you have a question about the a2000 and is the answer not in the manual?
Questions and answers