Advertisement
Care and Maintenance
The Frame
the tubular frame is very strong and corrosion resistant. Basic
maintenance is required, generally every 2 to 3 months, after
extensive use, or if water has flooded the kayak. disassemble
the kayak frame. Completely rinse the inside and outside of the
tubes with fresh water. keep frame inserts and extension bars
free of sand and grit.
using rubber gloves, coat the frame inserts and sliding sections
with Bo-shield t-9 (a small bottle is included in the repair kit).
Made by Boeing, this is an excellent lubricant and protectant.
Apply this to the frame prior to assembly to allow tubes to
slide together more easily. this product can usually be found in
marine hardware stores and some bike shops.
Apply the lubricant liberally to all sliding pieces and spring
buttons to prevent parts from seizing, if you plan to leave the
kayak assembled for a couple of months.
After paddling, sponge out water that may have pooled along
the keel.
The Skin
the urethane skin fabric is very uv and abrasion resistant, given
normal use. do not store outside, unprotected. the fabric can
be affected if continually stored in moist and damp conditions.
do not store the skin rolled up wet. Care must be taken when
approaching rocks, barnacles or shells. to avoid puncturing the
hull, exit the kayak and lift over any sharp surfaces. do not pull a
loaded boat over rocks or carry a loaded kayak.
A patch kit is included for repairs. urethane adhesive is used to
apply any patches or fill nicks. Instructions for patching are on the
adhesive. duct tape will also work well, and is a good addition to
your repair kit.
Feathercraft
kurrent
5
Advertisement
