Troubleshooting; Overview; Installation Problems - Brother DCP-315CN Network User's Manual

6

Troubleshooting

6

Overview

This chapter describes procedures for troubleshooting problems you
may encounter with a Brother Print/Scan server, it is divided into the
following sections:
1

Installation Problems

2
Intermittent Problems
3
Protocol-Specific Troubleshooting
Installation problems
If you cannot print over the network, check the following:
1
Make sure that the machine is powered on, is on-line and ready
to print.
Verify that the machine and the configuration are correct by
printing the Network configuration page. Refer to 3-19 of this
user's guide. If the test fails, check:
a
If the LCD does not display "LAN Active" after being
connected to the network, then the network firmware settings
may be corrupted. Please refer to Step 3.
b
In this event, try to restore the factory default settings of the
Print/Scan server from the menu. (See Restoring the Network
Settings to Factory Default on page 3-20) Once you have
done that, switch the machine off then on again, then try to
print out the Network configuration page. (See Network
Configuration List on page 3-19)
TROUBLESHOOTING 6 - 1