Brother DCP-110C Quick Setup Manual page 8

Step 1
3
Remove the protective parts.
Do not throw away the protective parts.
You will need them when you transport the
machine.
4
Take out the ink cartridge.
5
Carefully remove the bottom cap.
DO NOT touch the area shown in the
illustration below.
Opening
If the cartridge cover comes off when you
open the bag the cartridge will not be
damaged.
Keep the ink cartridge in an upright position
when you insert it into the slot.
OK OK OK
6
Setting Up the Machine
6
Press firmly down on the ink cartridge until
the hook snaps over it, taking care to match
the slot color (A) with the cartridge color (B),
as shown in the diagram below.
(A)
OK OK OK
7
Lift the scanner cover to release the lock.
Gently push the scanner cover support
down and close the scanner cover.
If shows on the LCD after you
Install
install the ink cartridges, check to make sure
the ink cartridges are installed correctly.
The machine will clean the ink tube system
for use for the first time. This process will
occur only once, the first time ink cartridges
are installed. The cleaning process will last
approximately four minutes.
The LCD shows:
Preparing System
Approx 4 Minutes
(B)