TechniSat DIGITRADIO 307 Instruction Manual page 52

Volume
> Finally, you can set the alarm volume using the TUNING / SELECT knob. Press
the TUNING / SELECT knob to save the setting.
The time must be imported for the alarm to function properly. For more
details, see Section 10.1.2.
When an alarm is active, an alarm symbol appears on the display.
9.2.2 Switching off the alarm after being woken up
> Press the On / Standby button on the device to switch the alarm off. Press
DIMMER / SNOOZE (6) to activate the snooze function.
10 System settings
All settings explained in this section apply equally to all sources.
> Open the menu and select > [System settings] using the TUNING / SELECT
knob. Press the TUNING / SELECT knob, to open the system settings.
10.1 Date and time settings
10.1.1 Manually setting the date / time
Depending on the setting for time updates (Section 10.1.2), the date and time may
have to be set manually.
> Open the MENU > [System settings] > [Date / Time] and press the TUNING /
SELECT knob.
> Use the TUNING / SELECT knob to select the entry [Date / Time setting] and
press the TUNING / SELECT knob.
> The first digits (day) of the date flash and can be changed using the TUNING /
SELECT knob.
> Press the TUNING / SELECT knob to accept the setting.
> The next date digits (month) then start to flash and can again be changed as
described above.
> Press the TUNING / SELECT knob after each additional setting to go to the
next setting.
> Proceed with the time in the same way as described above.
> After all settings have been applied and the TUNING / SELECT knob has been
pressed for the final time, [Time Saved] appears on the display.
52