Leica ML180 Series Quick Start Manual

Table of Contents

Download this manual

The ML 180 and the receiver should be paired already. However, if some problems occur with the connec-

tion between device and receiver, repeat the pairing procedure - follow the instructions below. (Take care

that you press all 3 buttons on the device simultaneously to switch it on...)

How long should I press the Smart Targeting key?

ceiver on your target and the ML device starts to rotate so that the laser beam catches the

receiver. This can be done in a range of +/- 4°. (To set the device to 0° position, press

Smart Targeting key short.)

Get Prepared

FAQs Leica Lino ML

Make sure, that the Smart Targeting key is pressed min.

2sec – press it as long as 2 red LEDS start to blink on

the XCR Catch receiver. Now you can position the re-

Table of Contents

Do you have a question about the ML180 Series and is the answer not in the manual?

Page 1 Get Prepared FAQs Leica Lino ML PAIRING XCRCatch The ML 180 and the receiver should be paired already. However, if some problems occur with the connec- tion between device and receiver, repeat the pairing procedure - follow the instructions below. (Take care that you press all 3 buttons on the device simultaneously to switch it on...)
Page 2 SMART TARGETING - PAIRING : SHORT PRESS If I press the Smart Targeting key short, the device starts to rotate – what does this mean? Pressing the Smart targeting function shortly means that the device goes back to the 0° (default position in the middle).
Page 3 CONTINOUS SMART TARGETING FUNCTION (Automatic alignment) The continuous Smart Targeting function is selected, but does not start? Pressing Sensitivity key and Smart Targeting key simultaneously is sometimes difficult to handle. If the Sensitivity key is pressed first, it changes only the sensitivity and you see that the sensitivity icon changes in the display and the continuous function is not activated.

Ml90 series