Culligan Aquasential Cullar Owner's Manual page 23

Culligan Aquasential Smart High Efficiency 9" Filtr-Cleer, 10" Filtr-Cleer,
9" Filtr-Cleer Outdoor, and 10" Filtr-Cleer Outdoor Water Filter
Culligan knows the more informed you are about your water treatment systems, the more confident you will be about its performance� It's because
of this and more than seventy years of commitment to customer satisfaction that Culligan is providing this Performance Data Sheet to its customers�
NOTE!
Read this Performance Data Sheet and compare the capabilities of this unit with your actual water treatment needs.
It is recommended that before purchasing a water treatment unit, you have your water supply tested to determine
your actual water treatment needs.
Manufacturer: Culligan International Company
9399 W� Higgins Rd�, Suite 1100
Rosemont, IL 60018 USA
(847) 430-2800
www�culligan�com
Product: Culligan Aquasential Smart High Efficiency 9" Filtr-Cleer, 10" Filtr-Cleer, 9" Filtr-Cleer Outdoor, and 10" Filtr-Cleer Outdoor Water Filter
Testing Conditions & Results:
Pressure: 60 psi
Service Flow Rate: 7�6 gpm @ 15�0 psi for 9" filters
8�1 gpm @ 15�0 psi for 10" filters
Operating Conditions:
Operating Temp� Range:
Electrical Characteristics: 24 VDC, 21�6 Watts
Substance Reduction
While testing was performed under standard laboratory conditions, actual performance may vary�
Name of Substance
Particulate, Class IV particles (≥ 15 μm to < 30 μm)
The Culligan Aquasential Smart High Efficiency Filtr-Cleer filters have been tested and
certified by WQA against NSF/ANSI Standard 372, CSA B483�1, and NSF/ANSI Standard
42 for Class IV (≥ 15 μm to < 30 μm) particulate reduction, as verified and substantiated by
test data� The concentration of the indicated substances in water entering the system was
reduced to a concentration less than or equal to the permissible limit for water leaving the
system, as specified in NSF/ANSI 42�
Performance Indicator: If water flow decreases or a noticeable taste change occurs a reconditioning cycle should be initiated� If conditions do
not improve, contact your local Culligan dealer� They can determine if your filter requires servicing� Do not use with water that is microbiologically
unsafe or of unknown quality without adequate disinfection before or after the system� Refer to the Specifications, Familiarization and Warranty
section of this Owner's Guide (P/N 01040707) for more specific product information� To avoid contamination from improper handling and
installation, your system should only be installed and serviced by your Culligan dealer� Performance will vary based on local water conditions�
The substances reduced by this system are not necessarily in your water�
Buyer Signature _______________________________________________________________________ Date ____________________
Seller Signature _______________________________________________________________________ Date ____________________
23
01040707 B 07/21
33 - 120°F (1 - 50°C)
Influent Challenge Concentration
Temperature: 63 - 73° F (17 - 23° C)
pH: 4�9 -5�5
Water Press� Range:
Water Press� Range (Canada):
At least 1,000 particles/mL
20 - 120 psi (140 - 830 kPa)
20 - 90 psi (140 - 620 kPa)
Reduction Requirement
≥ 85%