Advertisement
2
PRODUCT DESCRIPTION
2
PRODUCT DESCRIPTION
The BiDi-WiFi accessory is a device that – by means of WiFi com-
munication – allows for controlling the movement and status of
Gate&Door-type Nice automations compatible with the BusT4.
a
CAUTION! – Any use other than that specified here-
in or in environmental conditions other than those
stated in this manual is to be considered improper
and is strictly forbidden!
2.1 LIST OF CONSTITUENT PARTS
Figure 1 shows the main parts making up the BiDi-WiFi.
1
A
A
Data Connection LED
B
PAIRING button
C
RESET button
D
Power LED
E
Control Unit CONNECTOR
B
C
D
E
3
INSTALLATION
3
INSTALLATION
3.1 PRE-INSTALLATION CHECKS
a
The installation must be carried out by qualified
personnel in compliance with the current legisla-
tion, standards and regulations, and with the in-
structions provided in this manual.
a
CAUTION! – If the BusT4 connection is used for the
IBT4N interface, BiDi-WiFi cannot be connected to
the control unit.
Before proceeding with the product's installation, it is necessary to:
– check that you have a Nice automation control unit of the Gate&-
Door catalogue equipped with BUS T4 connector (IBT4N). Con-
trol unit with phone connector RJ11 are not supported by Bi-
Di-WiFi ("Figure 2")
2
RJ11
– you have a smartphone with Android 6.0.2 or higher
– you have installed and configured the application MyNice Pro
on the smartphone, you can download the App from Play Store.
3.2 INSTALLATION
To install BiDi-WiFi:
– disconnect the power supply from the automation's control unit
("Figure 3")
– all LEDs on the automation's control unit should be off before
continuing
3
OFF
– if present, remove the plastic pre-cut element (A) from the IBT4N
connector and check that there are no burrs ("Figure 4")
4
A
ENGLISH – 3
Advertisement
