Table of Contents
Advertisement
4 Shipment and on-site trans-
port
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol-
lows:
1. Check the scope of delivery. Check that
the specifications on the nameplate and
on the regulator itself match the specifi-
cations in the delivery note. See the
'Markings on the regulator' section for
nameplate details.
2. Check the shipment for transportation
damage. Report any damage to SAM-
SON and the forwarding agent (refer to
delivery note).
3. Determine the weight and dimensions of
the units to be lifted and transported in
order to select the appropriate lifting
equipment and lifting accessories. Refer
to the transport documents and the 'De-
sign and principle of operation' section.
EB 2090 EN
Shipment and on-site transport
4.2 Removing the packaging
from the regulator
The regulator is delivered as a single unit.
Î Do not open or remove the packaging
until immediately before lifting to install
the regulator into the pipeline.
Î Leave the regulator in its transport con-
tainer or on the pallet to transport it on
site.
Î Do not remove the protective packaging
from the regulator until immediately be-
fore installing it into the pipeline. This
packaging prevents the regulator from
becoming contaminated and moisture or
foreign particles from entering.
Î Dispose and recycle the packaging in ac-
cordance with the local regulations.
4.3 Transporting and lifting the
regulator
Due to the low service weight, lifting equip-
ment is not required to lift and transport the
regulator (e.g. to install it into the pipeline).
Î Leave the regulator in its transport con-
tainer or on the pallet to transport it.
Î Observe the transport instructions.
Transport instructions
Î Protect the regulator against external in-
fluences (e.g. impact).
Î Do not damage the protective packag-
ing.
4-1
Advertisement
Table of Contents
