Setup (1St Time Operation); Find Ip Address To Connect To - Woodward RP-3000XT Manual

4

Setup (1st Time Operation)

Pre-Conditions
4.1

Find IP Address To Connect To

Find easYgen-XT IP address
37593B
Remote Panel RP-3000XT Application comes with
three main screens:
MULTICAST
–
SETTINGS
–
BASE
–
There are just a few and close to self-explaining
steps to connect and control remotely
empower devices
–
select easYgen to connect to
–
– use RP-3000XT touch screen like easYgen
HMI
(One time) Network settings are easy and fully
supported by the RP-3000XT application software.
Ä Chapter 4.2 "Setup Ethernet Network Connection" on page 24
describes the steps when Ethernet network adjustment is neces‐
sary. After this is done one time, auto-setup will end with the BASE
screen of the preferred easYgen-XT device to be remotely con‐
Ä Chapter 5 "Operation" on page 31 starts with the
trolled.
assumption of this successful remote connection via the Ethernet
network.
The Remote Panel is connected over Ethernet with the
n
easYgen-3000XT network A
Both devices
n
– are powered up
and
– have booted
The IP address and range of the easYgen-XT device to be
remotely controlled must be known or figured out.
Navigate on the easYgen-XT HMI or ToolKit to the visualization
screen "Next Page è Diagnostic è Interfaces è Ethernet
Ethernet A" . Here you can see the current active IP address of
è
the easYgen-XT device and the according subnet mask:
RP-3000XT | Remote Panel
Setup (1st Time Operation)
Find IP Address To Connect To
23