Additional Message Center Operations; Setting Maximum Time For Incoming Messages; Setting Toll Saver - Brother FAX-2480C User Manual

To erase all of your messages
a
Press Erase.
b
Press a or b to choose one of the
options below. Then press OK.
Erase All Voice? All voice message
All fax messages
Erase All Fax?
All voice and fax
Erase All Msg.?
message
c
Do one of the following:
Press 1 to erase all of your
messages.
Press 2 to cancel.
d
Press Stop/Exit.
Message Center (FAX-2580C only)
Additional Message
9
Center operations
Setting maximum time for
incoming messages
Your machine's default setting will save
incoming messages up to 30 seconds long.
To change this setting follow the steps below:
a
Press Menu, 2, 7, 2.
7.Setup Msg Ctr
2.ICM Max.Time
b
Press a or b to choose the maximum
time setting for incoming messages (30,
60, 120 or 180 seconds). Press OK.
c
Press Stop/Exit.

Setting toll saver

When the toll saver feature is on, the machine
will answer after two rings if you do have
voice or fax messages, and after four rings if
you do not have any messages.
This way, when you call your machine for
remote retrieval, if it rings three times, you
have no messages and can hang up to avoid
a toll charge.
The toll saver feature is only available when
Message Center mode is on. When toll saver
is On, it overrides your ring delay setting.If
you are using Distinctive Ring, do not use the
Toll Saver feature.
a
Make sure you are in fax mode. If not
then press
b
Press Menu, 2, 1, 1.
1.Setup Receive
1.Ring Delay
(Fax).
59
9
9
9
9