Closing The Beds (Jay Feather Exp Only) - Jayco Jay Feather 2005 Owner's Manual

CLOSING THE BEDS (JAY FEATHER EXP ONLY)

Caution: Let the tent dry thoroughly before storing to prevent mildew and odors. If it
is necessary to put the tent away wet or damp, at the earliest possible time, open the
tent and allow it to dry thoroughly. Mildew is not covered by your warranty.
1. Remove the bed bow brace from the ceiling by pushing in on the button and pulling
down. Pull the brace toward you to remove it from the bow peg (on the bed bow).
.
NOTE: The small mat may need to be lifted slightly to set on top of any
obstructions and avoid pinching the mat when the bed board is closed.
2. Slide the small bed mat onto the large bed mat. From the far side of the large bed mat,
pull the mat up to set on its edge. (Fig. 27)
3. Hook up the canvas straps to the hasp d-ring located on the ceiling.
4. Exit the travel trailer. Unsnap the sides of the tent and
fold the bed bow down to the bed board. Unsnap the
end of the tent.
5. Fold in the tent onto the bed board. Important: Make
sure the bed tent is pushed in at least 1" above the side
bulb seal. (Fig. 28)
6. Push the bed board up into position. Secure the
latches or knobs to hold the bed board into place.
Caution: If the bed does not close easily, inspect the bed
cushion from the sides looking for obstructions. Once
the obstruction is located, lower the bed board, correct
the obstruction and try again.
Jay Feather Conventional Travel Trailer
Fig. 27
Preparing to Travel Home...
Fig. 28
71