Bed Set Up (Jay Feather Exp Only); To Set Up Front And Rear Beds - Jayco Jay Feather 2005 Owner's Manual

BED SET UP (JAY FEATHER EXP ONLY)

To Set Up Front and Rear Beds

.
NOTE: For storing purposes, the Jay Feather EXP trailer front bed is equipped with
canvas straps to hold the bed mats. Prior to setting up the bed(s), the canvas straps
should be unhooked by using the clips at the top edge.
1. Unscrew the knobs (Fig. 6) that hold the bed board in place to release the bed board.
2. The bed board is supported by cables attached to the trailer
and the corners of the bed board. Slowly lower the bed
board into position. Do not drop the bed board into
position. Maintain pressure on the bed board until the
cables are fully extended.
Caution: Dropping the bed board could cause undo pressure
on the trailer, cable and bed board.
3. Pull the tent out and over the
edges of the bed board. Snap the
end of the tent into place. Before
snapping the sides, make sure the
bed bow is pulled up to a vertical
position. Snap the sides of the tent
to the bed board. (Fig. 7)
4. Enter the unit and push the bed
mats out onto the bed board.
Position the large mat out to the
furthest edge of the bed board.
Slide the small mat toward you
lining up the velcro pieces to hold
it in place.
5. Place the straight end of the bed
bow support pole onto the bed
bow brace connector (on the bed
bow). (Fig. 8) Push the bed bow
outward and upward while
pressing the second button from the curved end of the bed
bow support pole. Slip the pole into the bracket, mounted on
the roof, just past the first button. Release the button.
6. Fold the canvas straps under the front edge of the small bed
mat.
Jay Feather Conventional Travel Trailer
Setting Up Camp...
Fig. 6
Fig. 7
Fig. 8
39