F*").",. j] -&)0*&, PWR (Power ON/OFF) Press this button to turn the monitor on/off. When the power is on, the LED on monitor will light up. SEL (Menu Selector, AV1/AV2 Selection) 1. Long press this button to switch menus. The cycle is as follows.
(&))%=*&,+4 G0)5&/*+ "). h/63%,+ Connectors, Pin-outs & Jumpers The following table is a listing of all back panel connectors associated with the UltraBrite2™. Connector Connector Symb Comment Type Label Description/Function HD COMPONENT INPUT, GREEN ANALOG B/Pb HD COMPONENT INPUT, BLUE ANALOG R/Pr HD COMPONENT INPUT, RED ANALOG HIROSE HR10-7R-4S...
Connector Connector Type Label Symbol Description/Function Comments HDB-15 VGA/RGB Red, analog HDB-15 VGA/RGB Green, analog HDB-15 VGA/RGB Blue analog HDB-15 VGA/RGB Reserved for monitor ID bit 2 (grounded) HDB-15 VGA/RGB DGND Digital ground HDB-15 VGA/RGB AGND Analog ground red HDB-15 VGA/RGB AGND Analog ground green...
Page 74
Termination Jumper Settings The factory default setting for all 75! termination jumpers for Composite, S-Video and Component inputs is set to on, or terminated. Jumper Composite video-in terminator enable Open = composite video input is not terminated Close = composite video input is terminated with 75!. “Only applies to video signals input via the Video BNC connector or via the 4-pin Hirose and 8-pin Lemo connectors when optional frameline generator is not installed.)
Need help?
Do you have a question about the STEADICAM Clipper 312 and is the answer not in the manual?
Questions and answers