Additional Functions - Slendertone CoreFit Instruction Manual

ADDITIONAL FUNCTIONS

Mute Function on/off (Fig. n):
Press and hold the P button for two seconds to mute/unmute
the controller.
: In the event of your product detecting an error, the
N
OTE
controller will unmute to indicate the error. You must reset
the mute manually if this occurs.
Keylock Function on/off (Fig. o):
Press and hold the Program and Intensity Up buttons for
two seconds. Repeat this to unlock.
Error Messages:
In the unlikely event of your product developing a problem,
the warning symbol and error code will appear on your
controller's display (Fig. p). If this occurs, you should switch
the controller off and then switch it back on again. It should
now operate properly. If the problem persists, please contact
for further assistance at:
SLENDERTONE
USA / Canada: 1-800-551-2443
International: +353 94 902 9936
Email: info@slendertone.com
GENERAL BATTERY ADVICE AND PRECAUTIONS
The controller contains 1 x 3.7 V Nominal Lithium Ion Polymer Battery.
Battery Charging & Discharging
• Your device is powered by a rechargeable battery. The battery can be charged and discharged hundreds
of times, but it will eventually wear out. To ensure optimum battery performance you should use your
device regularly.
• To conserve energy, disconnect the USB cable from the controller when the battery is fully charged.
• Leaving the battery in hot or cold places, such as in a closed car in summer or winter conditions, may
reduce the capacity and lifetime of the battery. A device with a hot or cold battery may cease working
temporarily, even when the battery is full charged. Battery performance is particularly limited in
temperatures below freezing.
• Do not dispose of batteries in a fire as they may explode. Batteries may also explode if damaged.
Dispose of batteries according to local regulations. Please recycle when possible. Do not dispose as
household waste.
Charging Specifications
When charging the battery, you must use a charger with the following outputs:
Output Voltage: 5V DC nominal.
Output Current: 0.5A (500mA) minimum.
Output Connector: Micro-B USB Connector.
Expected Service Life:
Controller: 2 years
Belt: 2 years
GelPads: 20-30 Sessions
Fig. n
Fig. o
Fig. p
11