Data Plate; Serial Number; Ce Label; Set-Up - Vaillant ecoVIT exclusiv Installation And Maintenance Instructions Manual

3.1.2 Rear connections
8
1 Recessed handles
2 Gas connection
3 Grommet
4 Heating flow connection
5 Cylinder return connec-
tion (when connecting a
domestic hot water cyl-
inder)
3.2

Data plate

The data plate is mounted on the rear of the electronics box
at the factory.
Information on the Meaning
data plate

Serial number

for identification; 7th to 16th digits =
product article number
VKK... Vaillant gas-fired floor-standing condens-
ing boiler
36 Power in kW
6 with condensing technology
/4 Product series
ecoVIT Product designation
exclusive Comfort fittings
G20 20 mbar Gas group and gas connection pressure
as set at the factory
Cat. (e.g. II ) Approved gas category
2H3P
Types (e.g. C ) Approved gas-fired units
33
0020258610_00 ecoVIT exclusiv Installation and maintenance instructions
1
2
3
4
5
6
7
6 Heating return connec-
tion
7 Opening for the con-
densate discharge con-
nection
8 Fastening for the flue
pipe retainer
Information on the Meaning
data plate
PMS (e.g. 3 bar Permissible total overpressure
(0.3 MPa))
T (e.g. 85 °C) Max. flow temperature
max.
230 V 50 Hz Electric connection
(e.g. 110) W Max. electrical power consumption
Class I Electrical protection class
IP (e.g. X4D) IP rating
Heating mode
P Nominal heat output range
Q Heat input range
Note
Make absolutely sure that the product is compat-
ible with the gas group at the installation site.
3.3 Serial number
The serial number can be found on a sticker behind the front
flap on the front below the control panel and on the data
plate.
3.4

CE label

The CE label shows that the products comply with the basic
requirements of the applicable directives as stated on the
identification plate.
The declaration of conformity can be viewed at the manufac-
turer's site.
4

Set-up

4.1

Transporting the product

Warning.
The high product weight poses a risk of
injury during transport.
Excessive load bearing may lead to injuries.
▶
Transport the product using a suitable
carrying aid or a suitable sack truck.
Caution.
Risk of material damage caused by incor-
rect use of the mode of transport.
A sack truck that is attached incorrectly may
damage the product's casing.
▶
Attach a sack truck only to the rear of the
product.
1. Secure the product to a suitable carrying aid or a suit-
able sack truck.
Set-up 4
7