WALTERSCHEID SW41 Operating Manual page 95

7. Insert the first circlip.
8. Place the second bearing bush on the
opposite cross journal. Pay attention
here that no bearing needles fall out of
the bearing bush.
9. Drive the second bearing bush into the
yoke so far until the ring groove is
visible.
9.1 Press the bearing bush (1) against
the mandrel (2) and operate the
foot switch simultaneously until the
ring groove is visible.
10. Insert the second circlip.
The yoke is mounted.
®
11. Insert the cross into the second yoke if
necessary.
12. Repeat the action steps 5 to 10 in order
to mount the third and fourth bearing
bushes.
Fig. 24
Fig. 25
Fig. 26
39