Mounting Yoke / Cross - WALTERSCHEID SW41 Operating Manual

DISMANTLING / MOUNTING YOKE / CROSS
7.2

Mounting yoke / cross

(1) Connecting fork (with cross pre-
mounted)
(2) Inboard yoke
(3) Bearing bush
(4) Circlip
1. Insert an appropriate mandrel (1) into
the quick-change system. The diameter
of the mandrel must correspond to the
drill hole diameters of the yokes.
2. Align the position of the mandrel (1)
opposite the bearing bush of the cross.
3. Lubricate the bearing needles of all
bearing bushes generously.
4. Insert the cross into the yoke.
5. Place the first bearing bush (2) on the
cross journal. Pay attention here that no
bearing needles fall out of the bearing
bush.
6. Drive the first bearing bush into the
yoke so far until the ring groove is
visible.
6.1 Press the bearing bush (1) against
the mandrel (2) and operate the
foot switch simultaneously until the
ring groove is visible.
38
Fig. 21
Fig. 22
Fig. 23