Intended Use; Danger Zone And Danger Points - WALTERSCHEID SW41 Operating Manual

2.3

Intended Use

2.4

Danger zone and danger points

The WALTERSCHEID special tool SW41 is exclusively
intended for the dismantling and mounting of yokes and
crosses by qualified skilled personnel. The special tool must
only be operated using an external compressed air system with
a maximum air pressure of 10 bar.
Proper use also includes:
the compliance with all instructions in this operating manual,
•
the compliance with the specified work for maintenance
•
and care of the special tool,
the exclusive use of original parts.
•
Any uses other than those above are prohibited and are
deemed as improper use.
For damage arising from improper use:
the owner bears the sole responsibility,
•
the manufacturer accepts no liability of any kind.
•
The danger zone is the area surrounding the special tool in
which hazards for the safety or health of persons can arise
during the pneumatically supported dismantling and mounting
of yokes and crosses.
No persons are permitted to be in the danger zone during the
pneumatically supported dismantling and mounting of yokes
and crosses.
The operator is only permitted to operate the special tool
pneumatically if there are no persons in the danger zone of the
special tool.
There are hazards in the danger zone from danger points which
cannot be completely eliminated with respect to the functional
safety of the special tool. The hazards are always present.
Danger points on the special tool are identified with warning
signs. The warning signs warn about the residual risks.
Action-related safety instructions in this operating manual
indicate the existing residual risks of the special tool.
11