Advertisement
Step 14
Carefully stand your unit upright.
å
Peel the BUMPERS from the BUMPER CARD (160M) and
å
stick them onto the front edge of the SHELF (L) as shown.
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the LEFT DOOR (P) to the left END (A) as shown
å
in the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a KNOB (134K) to the LEFT DOOR (P). Use one
å
BLACK 1-1/8" PAN HEAD SCREW (9S).
Repeat this step for the RIGHT DOOR (O).
å
See the next step for DOOR adjustments.
å
BLACK 1-1/8" PAN HEAD SCREW
(2 used for the KNOBS)
Page 18
134K
P
9S
A
L
160M
423661
Stop
Mounting
screw
Hinge
www.sauder.com/services
Advertisement
