Table of Contents
Advertisement
Installation Guide
__________________________________
Figure 2-18. Removing Blanking Cover.
______________________________________ _
Figure 2-19. Inserting The PC AD1200 Card.
Use the screw kept back from the blanking cover to screw the
PC AD1200 retaining bracket into the PC back panel housing.
Chapter 2
AD1200 Reference
STEP 4 Choose an empty
expansion
slot.
AD1200 card will fit either a
full length or a short slot, a 8
bit PC type slot or a 16 bit
AT type slot. In general it is
wise to leave the larger slots
free for those boards that insist
on greater room. Remove the
blanking cover protecting the
slot on the PC back panel.
KEEP
the
screw safely for later.
STEP 5 Now insert the PC
AD1200 card in the slot. Be
careful to ensure that the gold
plated pcb fingers fits neatly
into
the
connector. Press down firmly
but evenly on the top of the
PC AD1200 card.
STEP 6 The 50 way IDC
connector should fit neatly
through the slot's aperture to
the outside world.
The
PC
blanking
cover
i/o
expansion
Page 45
Advertisement
Table of Contents
