Hunter ICC Series Product Information page 16

Hunter Quick Check
™
To initiate the Hunter Quick Check
dure, press the , ,
same time. In the standby mode, the LCD will
display all segments (helpful when trouble-
shooting display problems). Press the
to begin the Quick Check test procedure.
If a field wiring "short" is detected, an "ERR"
symbol preceded by the station number will
momentarily flash on the LCD display.
One-Touch Manual Start and
Rapid Advance
1. Hold down the button for 2 seconds.
2. This feature automatically defaults to
Program A. You can select Program B, C or D
by pressing the button.
3. The station number will be flashing. Press the
or button to scroll through the stations
and use the or buttons to adjust the start
run times. (If no buttons are pressed during
step 2 or 3, the controller will automatically
begin Program A.)
4. Press the button to scroll to the station you
wish to begin with. After a 2-second pause, the
program will begin.
Test Program
To initiate the test program:
1. Press and hold the button. The station
number will be flashing.
2. Press the or button to scroll to the
station you would like the test program to start
with. Use the or button to set the run
time up to 15 minutes. The run time needs to
be entered only once.
3. After a 2-second pause, the test program
will begin.
14
test proce-
™
, buttons at the
button
The ICC is popular for commercial and
public area applications.