Troubleshooting - Dometic MoBar300S Operating Manual

Troubleshooting

Care and cleaning
!
WARNING! Health hazard
Many cleaning agents (e. g. acetone, ethyl alcohol) can be flammable,
corrosive and dangerous.
Always read the information on the packaging (especially the safety
instructions) before using them.
• Clean the stainless steel surface regularly and as soon as it is dirty.
• Generally it is sufficient to clean the stainless steel surface with warm water and
regular dishwashing detergent, afterwards rinse it with plenty of water and dry it
with a soft cloth.
Note: It is essential to dry the surface as water can leave residues (limescale).
• Stainless steel surfaces are in no way affected by frequent cleaning and can,
therefore, be cleaned any number of times without any problems.
10 Troubleshooting
If you are unable to solve a problem yourself, get in touch with customer services (see
backpage).
Problem
Device does not work.
Device is not cold
enough.
30
Possible cause
Device not connected to a
power supply
Device switched off
Circuit breaker or fuse blown
Temperature not set properly
Ambient temperature could
require a higher temperature
setting
Door opened frequently
Door not closed properly
Door not hermetically-sealed
MoBar300S/550S
Remedy
Connect the device.
Switch on the device.
Switch on circuit breaker or
replace fuse.
Check the set temperature.
Set a higher temperature.
Do not open the door more
often than necessary.
Close door properly.
Check the door seal and
clean or replace.
EN