Dometic MoBar300S Operating Manual page 31

MoBar300S/550S
Problem
Device switches itself on
and off.
The light does not work.
The device seems to
make a lot of noise.
The door does not close
properly.
LED indicates E1, E2 or E7. Temperature sensor for the fan
EN
Possible cause
The cabinet recently replenished
with new bottles
Door opened frequently
Door not closed properly
Door not hermetically-sealed
Device not connected to a
power supply
Circuit breaker or fuse blown
Light switched off on the control
panel
The noise is probably caused by the refrigerant, which is
normal. At the end of each cycle, you will hear noises made by
the flow of refrigerant.
If temperature fluctuations occur, the contraction and expansion
of the inner walls may cause popping and cracking noises.
High ambient temperature leads to constant operation of the
compressor which can lead to a lot of noise.
Door seal dirty
Shelves are not fitted correctly
inside the device shows an error
Troubleshooting
Remedy
Leave the device to work for
a while until the set tempera-
ture has been reached.
Do not open the door more
often than necessary.
Close door properly.
Check the door seal and
clean or replace.
Connect the device.
Switch on circuit breaker or
replace fuse.
Switch on the light.
Clean the door seal.
Check the shelves and refit
correctly.
This can only be repaired by
an authorized repair center.
31